Файл bsp_board_starterkit_lpc_1766.h

См. исходные тексты.

Макросы
#define	BSP_BOARD_HAS_CAN   0
#define	BSP_BOARD_HAS_ETHERNET   1
#define	BSP_BOARD_HAS_MMC   0
#define	BSP_BOARD_HAS_PS2   1
#define	BSP_BOARD_HAS_SD   0
#define	BSP_BOARD_HAS_SDRAM   0
#define	BSP_BOARD_HAS_SPI   1
#define	BSP_BOARD_HAS_SPI_VS1002D   1
#define	BSP_BOARD_HAS_UART0   1
#define	BSP_BOARD_HAS_USB   1
#define	BSP_BOARD_HAS_USB_DEVICE   1
	board has USB DEVICE on USB1
#define	BSP_BOARD_HAS_USB_HOST   1
	board has USB HOST on USB1
#define	bsp_board_starterkit_lpc_1766_stk   1
#define	BSP_USB_MODE_DEFINED   TYPE_HOST_PORT1
	it is a pity but port can be set manually
#define	CCLKCFG_Val   5
#define	CLKSRCSEL_Val   1/*CLKSRCSEL_XTAL*/
#define	CS_VS1002D   1
#define	i_ARCH   CM3
#define	i_BOARD   starterkit_SK-MLPC1768
#define	i_MCU_FAMILY   LPC17xx
#define	i_MCU_MODEL   1768
#define	i_VENDOR   olimex
#define	i_VERSION   0x01000B /* REVISION B version 1*/
#define	LPC2xxx_CLOCK_SETUP   1
#define	LPC2xxx_FLASH_SETUP   1
	Enabling MAM.
#define	LPC2xxx_PLL_SETUP   1
#define	LPC2xxx_SDRAM_SETUP   BSP_BOARD_HAS_SDRAM
#define	LPC2xxx_VIC_SETUP   1
#define	MAMCR_Val   LPC_SC_MAM_MODE_FULL
#define	P0_20_TP_CS   /* no need to chip select*/
#define	PLL_MValue   11
#define	PLL_NValue   0
#define	port_spi_chip_disselect(chip_num)   /* no need to chip select*/
#define	port_spi_chip_select(chip_num)   /* no need to chip select*/
#define	port_spi_chip_select_init()   /* no need to chip select*/
#define	USBCLKCFG_Val   5
#define	XTAL_HZ   12000000UL