Файл bsp_board_generic.h

См. исходные тексты.

Макросы
#define	bsp_board_generic   1
#define	BSP_BOARD_HAS_CAN   0
	board has CAN as IRDA
#define	BSP_BOARD_HAS_ETHERNET   0
	board has ETHERNET
#define	BSP_BOARD_HAS_I2C   0
#define	BSP_BOARD_HAS_I2C_PCA9532   0
#define	BSP_BOARD_HAS_MMC   0
#define	BSP_BOARD_HAS_SD   0
#define	BSP_BOARD_HAS_SDRAM   0
	board has SDRAM
#define	BSP_BOARD_HAS_SPI   0
#define	BSP_BOARD_HAS_SPI_TSC2046   0
#define	BSP_BOARD_HAS_UART0   1
	board has UART0
#define	BSP_BOARD_HAS_UART1   0
	board has UART1
#define	BSP_BOARD_HAS_UART2   0
	board has UART3 as IRDA
#define	BSP_BOARD_HAS_USB   0
	board has USB
#define	BSP_BOARD_HAS_USB_DEVICE   0
	board has USB DEVICE on USB2
#define	BSP_BOARD_HAS_USB_HOST   0
	board has USB HOST on USB1
#define	BSP_BOARD_HAS_USB_OTG   0
	board has OTG USB on USB2
#define	CCLKCFG_Val   3
#define	CLKSRCSEL_Val   CLKSRCSEL_XTAL
#define	i_ARCH   CM3
#define	i_BOARD   GENERIC_BOARD
#define	i_MCU_FAMILY   LPC17xx
#define	i_MCU_MODEL   1768
#define	i_VENDOR   GENERIC_VERNDOR
#define	i_VERSION   0x010100 /* version 1.1.0*/
#define	LPC2xxx_CLOCK_SETUP   1
#define	LPC2xxx_FLASH_SETUP   1
	Enabling MAM.
#define	LPC2xxx_PLL_SETUP   1
#define	LPC2xxx_SDRAM_SETUP   BSP_BOARD_HAS_SDRAM
#define	LPC2xxx_VIC_SETUP   1
#define	MAMCR_Val   LPC_SC_MAM_MODE_FULL
#define	PLL_MValue   11
#define	PLL_NValue   0
#define	port_spi_chip_disselect(chip_num)
#define	port_spi_chip_select(chip_num)
#define	port_spi_chip_select_init()
#define	USBCLKCFG_Val   5
#define	XTAL_HZ   12000000UL